|
|
 |
|
 |
| Communicating With and Programming Your EMC |
|
| We've been asked, "OK, your message centers are perfect for our church, but how hard are they to program and how do you get the messages on them?". It's easier than you think. |
|
| PROGRAMMING YOUR EMC |
|
Your electronic message center comes with software that allows you to place your messages, animations or graphics which is extremely easy to use. Once you install it on your computer you can have your first message on your EMC in a matter of minutes.
The software allows you to bring your messages on and off the sign in over 20 dynamic and fun ways like Zoom, Rotate, Drop, Sparkle, Scroll, and more. |
|
 |
|
| COMMUNICATING WITH YOUR EMC |
|
1) Radio Frequency Modem
This is the quickest and easiest way to communicate with your EMC. The radio frequency modem communicates wirelessly with your sign. You plug the radio frequency modem into your computer and you can immediately send the message you created with the software out to the sign.
The distance between the sign and the computer with the RF modem can be over a mile. |
|
 |
 |
|
2) Phone Modem
The phone modem uses a modem connected to the computer as well, but instead of operating wirelessly, you need to have a dedicated phone line run out to the sign and connected to the modem inside the sign. This option is optimal if your sign is a long distance from the place where the computer with the software on it will be. |
3) Direct Link to the Sign
There is also the option to link up directly with the sign with a communication cable. If you have a laptop computer this would work OK. You need to plug the communication cable into the laptop and then the sign. The software transmits the new message to the sign in seconds. |
|
